Vacuum packaging machine, these kinds of common failures, encountered how to solve?
As food packaging, face to face with consumer's line of defense, in which have played an important role in protecting food not only, more important point is to a certain extent, to promote the class of food packaging, and in the face of all kinds of different types of food, the food processing enterprise in order to attract the attention of consumers, in different packing form, At present, food packaging methods can be said to be multifancy.Among these different packaging methods, vacuum-packed food is very popular among modern consumers, because it not only extends the shelf life of food, but also enables some types of food to be ready to eat in an open bag, which is one of the common food for travel and leisure. In the process of using food processing enterprises, the vacuum packaging machine will inevitably appear some large and small failures, and in the face of these failures, how do you solve it? In view of this problem, we will go to the vacuum packaging machine manufacturer to have a detailed understanding.
The reasons for the failure of vacuum packaging machine are divided into many aspects. Next, we will take several common failures as an example to carry out a detailed analysis.
First, the upper cover of the vacuum chamber does not suck the cover
When the vacuum packaging machine is bought back, there will generally be no problems, but with the increase in the frequency of use, the problems will be exposed, and some problems you only need to master the simple technical knowledge, it will be easy to solve. Vacuum packing machine cover don't cover problems, for example, when equipment appear this kind of problem, main reason is because spring is loose, we in the use of vacuum packaging machine, vacuum packing machine cover around back and forth, is to continue the action against the spring, and does not appear this kind of vacuum packing machine lid suction cover problem, just need to spring screws are tight. In our daily maintenance and maintenance of the vacuum packaging machine, we need to often check whether the spring of the vacuum packaging machine is loose.
Two, only vacuumize not deflate
When we encounter this kind of vacuum packaging machine failure, it is caused by many aspects, so we need to go to check one by one. Specific identification methods are as follows:
1. When the equipment is running, observe whether the light of the time relay is on. If it is on, press the emergency stop switch to see the reaction of the equipment.
(1) If the equipment reacts to deflate, the time relay responsible for heating is faulty. At this time, a new time relay should be replaced.
(2) If the equipment does not vent, the vent valve responsible for the vent work energy is faulty, and the vent valve needs to be replaced.
2. If it is found that the light of the time relay is not on, there is something wrong with the travel switch. At this time, the travel switch should be replaced.
Three, one side of the vacuum chamber does not exhaust the phenomenon
The double chamber vacuum packing machine is generally composed of two vacuum chambers. When the phenomenon of pumping air while not pumping air occurs, it is mainly caused by the failure of the corresponding two-way valve. When the failure occurs, the new two-way valve should be replaced in time.
Have seen the introduction of the above of the common faults vacuum packaging machine, whether you also encountered in the process of daily use, vacuum packaging machine at the time of operation, in addition to need to master certain skills, also need to master some common fault elimination method, so that you can because at the time of operation to avoid artificial error caused by the occurrence of equipment failure rate, Thus prolong the service life of its equipment.