Use method of computer rolling vacuum packing machine

Computer rolling vacuum packing machine is a kind of automatic continuous working machine with high automation degree and production efficiency.The vacuum pump is installed outside the machine, and the transmission system and electrical system are in the boxes on both sides of the body.The working principle of computer rolling vacuum packing machine is that it adopts chain drive, automatic cover swing, continuous output of products, the whole machine adopts computer board control of waterproof and moisture-proof, the operating system is completely sealed, the whole machine can be rinsed with water.

Features and advantages of computerized rolling vacuum packaging machine:

1, touching screen control, simple easy to operate 2, all electrical system operation, the machine can use clean water to rinse the 3, the machine can tilt Angle, 30 degrees do sealing point 4, with the hand device, safe and reliable operation of 5, slow start, slow stop conveyer, reliable positioning 6, article heating fault alarm system, heating the final equipment for automatic stop and alarm prompt.7, improved transformer (with fuse protection device) and electric heating rod, electric tropical replacement simple, longer service life, sealing more beautiful and reliable.8, single operation, low labor intensity, can realize flow operation

Use method of computer rolling vacuum packing machine:

First: turn on the power switch (the power indicator is on).At this time, due to the memory function of the system control program, if there is an unfinished program before the last shutdown, it may trigger the upward movement of the upper studio (ZUI should make the equipment idle for 3-6 times before production).

Secondly, on the operating station, adjust the distance between the material baffle and the sealing line, and put the packing bags (the mouth of the bags should be clean and the margin should not be less than 40mm) on the working platform.Lift (open) the layering strip of the packaging bag and place the sealing position of the packaging bag on the silicone strip of the sealing, and put it firmly, spread, flatten and align, leaving room at both ends.When multiple bags are packed in the same room, they should not overlap each other.Put down the packing bag layering, adjust the packing bag sealing margin to the appropriate length, and finish the manual feeding operation (after entering the normal operation state, this process should be completed within a working cycle).

Third, press the "work" button and the equipment enters the cycle working state according to the set parameters. The operator repeats the actions specified in clause b to carry out production.When there is no product (material) on the conveyor belt or in the working room (vacuum room), the normal shutdown operation can be carried out.

To stop work, press the "stop" button to turn off the power switch of the equipment (the power indicator is off) and cut off the main power supply.

The "stop" button also has the "emergency stop" function. When the device is in operation state, if it needs to be stopped in an emergency, regardless of the program operation and manual operation in any state, the operation will be terminated immediately after each press of the "stop" button until the "work" button is pressed again and the travel switch is released.

Computer rolling vacuum packaging machine can be understood as a batch production of small packaging production line, eliminating the need to manually grasp the top cover to press down the process, will gradually become the main force of vacuum packaging industry!